The Herrington Arms HCDG Compensator is designed to work with the Palmetto State Armory Dagger series. The HCDG Compensator for the Palmetto State Armory Dagger will work with the stock springs provided your gun has gone through our recommended break in period of 500 rounds factory new ammunition is used with the threaded barrel you intend to use with the firearm. Fits on factory 1/2-28 threaded barrels or most aftermarket Glock barrel.
Specifications
- Material: 7075 Aluminum
- Finish: Black Anodize, FDE Cerakote, Sniper Green Cerakote, and Sniper Grey Cerakote
- Compatibility: PSA Daggers (specified below) with a 1/2-28 threaded barrel
- Length: .85" Long
- Included: 5/64 Allen key, Steel replacement 8-32 set screws
Product Fitment
The HCDG FINNED compensator will fit the following:
- Extreme Carry Cut (ECC)
- SW1
- SW2
- SW3
- SW4
- SW6
- SWR
- X1 - May have a slight gap, NO FIN is suggested.
- SWRV2
THE HCDG NO FIN WILL WORK WITH ALL PSA DAGGER SLIDES AND MOST GEN 1-3 GLOCK SLIDES/CLONES!
Highlights
- Engineered to greatly reduce vertical recoil of your gun
- Highly durable 7075 Aluminum for extreme longevity and lightness
- Uses Steel replacement 8-32 set screws
- WILL NOT WORK ON THE MICRO DAGGER
- THE NO FIN HCDG will work with the Ruger RXM
- DOES NOT WORK WITH KKM OR BARSTO BARRELS
- REQUIRES A THREADED BARREL
- Works with ONLY PSA Dagger 9mm models
- Length is .85" inches long
- Blems are cosmetic ONLY. They will function as normal
INSTALLATION INSTRUCTIONS
- Make sure all threads are clean of grease, carbon, and loctite. Wipe the threads down till they're clean. If the threads are not cleaned, the loctite will not set properly.
- Only use loctite 243 on the barrel AND set screw threads. Some versions of the blue Loctite are not very strong and will not hold up. Feel free to use a generous amount.
- Torque the set screws to no more than 18in/lbs for 8-32 set screws and no more than 11in/lbs for 6-32 set screws.
- Allow the loctite to set for 24-48 hours before using.
- Please be sure that the compensator is not touching the slide, frame, or guide rod as that can cause cycling issues.