The Herrington Arms HC92PV2 is designed to match the contour of Glock Gen 5 and Gen 6 slides with fins, while our no-fin version fits Gen 4, 5, and 6 slides, as well as aftermarket Glock slides. This V2 model keeps the same port geometry as the original V1, but adds refined aesthetics and lighting cuts tailored to Gen 5 and 6 slides.
Both the V1 and V2 use a dual-top-port-only design built for close-retention shooting, directing gas away from the shooter's face instead of out the side ports. The HC92P runs on stock springs, provided your firearm has completed our recommended break-in period: 500 rounds of factory-new ammunition fired through the threaded barrel you intend to use, completed before installing the compensator. In testing, we've measured a 35.4% reduction in muzzle flip, depending on the 9mm load and Glock model used.
Material : 7075 Aluminum
Finish : Black Anodized or FDE Cerakote
Compatibility:
FINNED: ONLY Glock 17/19/26/45/34/19x GEN 5 and GEN 6 (including the MOS models of) with 1/2-28 Barrels.
NO FIN: Glock 17/19/26/45/34/19x/47 (including the MOS models of) with 1/2-28 Barrels, GEN 4, 5, and 6 Glocks. This is also a good option for aftermarket slides on both the GEN 5 and GEN 4 platforms. This will also fit the Shadow System MR, DR, and XR series, Lonewolf Arms Timberwolf and Dusk series, and most Glock clones based around the Gen 4 and Gen 5 models.
Included : 5/64 Allen key - Steel replacement 8-32 set screw
Length : 1.125 " long
Holster Compatibility : Will fit in most open bottom holsters. We use Sierra Defense, Tier 1 Concealed, and Safariland.
Highlights
- Dual top port design to mitigate 35.5% of vertical recoil
- Will fit in most open bottom holsters. We use Sierra Defense, Tier 1 Concealed, and Safariland.
- NOT COMPATIBLE WITH SILENCERCO, BAR-STO, KKM, OR EFK BARRELS
- Works with Gen 4 (NO FIN) and Gen 5 & 6 (FINNED) Glock 9mm handguns
- Blems are cosmetic ONLY. They will function as normal - May have nicks, dings, pitting, machining marks, chips, discoloration, etc.
AMMO DISCLAIMER: We DO NOT recommend using plated, bi-metal, or frangible ammo in ANY of our compensators. Doing so will void the warranty and we will not cover or replace the comp if there are any damages.
INSTALLATION INSTRUCTIONS
- Make sure all threads are clean of grease, carbon, and loctite. Wipe the threads down till they're clean. If the threads are not cleaned, the loctite will not set properly.
- Only use loctite 243 on the barrel AND set screw threads. Some versions of the blue Loctite are not very strong and will not hold up. Feel free to use a generous amount.
- Torque the set screws to no more than 18in/lbs for 8-32 set screws and no more than 11in/lbs for 6-32 set screws.
- Allow the loctite to set for 24-48 hours before using.
- Please be sure that the compensator is not touching the slide, frame, or guide rod as that can cause cycling issues.
DISCLAIMER: This product is not manufactured, authorized, endorsed,
or warranted by GLOCK. GLOCK does not warrant or represent that
this product is compatible with GLOCK pistols.
